■ 流量計在水平管道上的安裝Installation of flowmeter on horizontal pipelines
▲ 在水平管道上安裝是流量計常用的安裝方式
installation of flowmeter on horizontal pipelines is the most common installation mode
▲ 測量氣體流量時,若被測氣體中含有少量的液體,流量計應安裝在管線的較高處.
When the flowmeter is used to measure gas flow,if there is small amount of liquid in the gas,the flowmeter shall be installed at the higher position of the pipeline.
▲ 測量液體流量時,若被測液體中含有少量的氣體,流量計應安裝在管線的較低處
When the flowmeter is used to measure liquid flow,if there is small amount of gas in the liquid,the flowmeter shall be installed at the lower position of the pipeline.
■ 流量計在垂直管道的安裝
Installation of flowmeter on vertical pipelines
▲ 測量氣體流量時,流量計可以安裝在垂直管道上,流向不限.
When the flowmeter is used to measure gas flow,the flowmeter can be installed on the vertical pipelineand the flow direction is not limited.
▲ 若被測氣體中含有少量的液體,氣體流向應由上而下.
if there is small amount of liquid in the measured gas, the gas shall flow upwardly from the lower position.
▲ 測量液體流量時,液體流向應由下向上
When the flowmeter is used to measure liquid flow,the liquid shall flow upwardly from the lower position.
■ 流量計和顯示儀運行前的準備工作
Preparation before the operation of flowmeter and display meter.
▲ 仔細檢查流量計的安裝,接線等是否正確無誤.
▲ 接通顯示儀電源,觀察顯示儀是否有流量顯示.
▲ 緩慢打開閥門,到一個較小壓力時停止,觀察傳感器周?chē)欠裼行孤冬F(xiàn)象,并觀察顯示儀是否有流量顯示
▲ .若情況正常,開大閥門,穩定一段時間后,觀察儀表顯示的流量是否正常.
▲ Check the installation of the flowmeter carefully,and whether the wiring etc,is done in correct way,
▲ Connect with the power supply of the display meter,and observe whether there is flow display on the display meter.
▲ Open the value slowly and stop when the pressure is relatively low.Observe whether there is leakage around the sensor,and observe whether there is flow display on the display meter.
▲ If they are in normal condition,further open the value,and after it is stabilized for a while,observe whether the flow displayed on the meter is normal.