5725A的電壓輸出可在5700A系列校準器的5725A的電壓輸出可在5700A系列校準器的前或后結合柱上使用。這就消除了在需要放大和標準校準輸出的過程中移動電纜的需要。前或后結合柱上使用。這就消除了在需要放大和標準校準輸出的過程中移動電纜的需要。
5725A前端或后面板輸出綁定位置僅用于當前輸出。通過它們提供了擴展范圍的交流和直流電流。由于大多數高電流范圍的電表都使用一個單獨的高電流輸入端子，這種配置通常不需要在過程中移動電纜。如果需要一個單點電流輸出，則可以配置5700A系列校正器，通過5725A的綁定位置來輸出所有當前輸出。
型號5725A操作功能和范圍:
交流電壓:220v至1100 V rms至70 mA (50 mA < 5 kHz)， 40hz至30khz;220至750V rms最高可達70 mA, 30 kHz至100khz。
直流電流:0 A到11 A。
交流電:1 A到11 A rms, 40hz到10khz。
The 5725A Amplifier enhances the 5700A Series Multifunction Calibrators in the ac voltage, ac current, and dc current functions. The 5725A operates under complete control of the 5700A Series calibrators through an interface cable supplied with the 5725A.
Enhancements to 5700A/5720A ac voltage output capability provided by the 5725A:
Frequency limits at higher voltage increase to 100 kHz at 750 V, 30 kHz at 1100 V
Load limits are to 70 mA for frequencies above 5 kHz, and to 50 mA for frequencies less than 5 kHz
Capacitive load limits are increased to 1000 pF
Voltage output from the 5725A is available at the 5700A Series Calibrators' front or rear binding posts. This eliminates the need to move cables during a procedure that requires amplified as well as standard calibrator outputs.
The 5725A front or rear panel OUTPUT binding posts are only for current output. Extended-range ac and dc current is supplied through them. Since most meters with a high current range use a separate high current input terminal, this configuration normally eliminates the need to move cables during a procedure. If a single-point current output is needed, the 5700A Series Calibrator can be configured to source all current outputs through the 5725A binding posts.
Model 5725A operating functions and ranges:
AC voltage: 220 V to 1100 V rms up to 70 mA (50 mA < 5 kHz), 40 Hz to 30 kHz; 220 to 750V rms up to 70 mA, 30 kHz to 100 kHz
DC current: 0 A to ±11 A
AC current: 1 A to 11 A rms, 40 Hz to 10 kHz
采購中心
